aFe Takeda Momentum Cold Air Intake fits 2016-2023 Toyota Tacoma 3.5L

aFe Takeda Momentum Cold Air Intake for the 2016-2023 Toyota Tacoma 3.5L V6

Wake up your 3rd gen Tacoma's 3.5L V6 with the aFe POWER Takeda Momentum Cold Air Intake System. The smooth one-piece sealed housing is constructed of heat-resistant cross-linked polyethylene (XLPE) to block engine heat and feed the motor cooler, denser air, and it outflows the factory intake by 35% (385 CFM at 7" H2O). A clear sight window lets you check filter condition without opening the box.

The computer-designed, dyno-tuned XLPE intake tube resists heat soak, and the massive 9" tall 360-degree radial flow filter uses aFe's inverted-top design to pack the largest filter possible into the housing. aFe's testing shows gains up to +5 horsepower and +4 lb-ft of torque, with sharper throttle response you'll feel every time you get on it. Installation takes about an hour with basic hand tools, no tune required.

Pick your filter media: the Pro 5R is oiled five-layer cotton gauze optimized for maximum airflow, while the Pro DRY S is a no-oil three-layer synthetic that cleans up with soap and water, a favorite for dusty off-road use since there's no re-oiling to mess with.

Key Features

• Outflows the factory intake by 35% (385 CFM @ 7" H2O)
• aFe dyno-tested gains up to +5 HP and +4 lb-ft TQ
• One-piece sealed XLPE housing blocks engine heat, with clear sight window
• Dyno-tuned XLPE intake tube resists heat soak
• 9" tall 360-degree radial flow filter, choice of Pro 5R oiled or Pro DRY S dry media
• Washable, reusable filter with extended service intervals
• Installs in about an hour with basic hand tools, no tune required

Fitment

• 2016-2023 Toyota Tacoma (3rd gen) with the 3.5L V6 (2GR-FKS)
• Emissions note: not currently CARB exempt, not available for sale to California or CA-registered vehicles

What's Included

• aFe Takeda Momentum intake housing and dyno-tuned intake tube
• Pro 5R or Pro DRY S air filter (your choice)
• Silicone couplings and stainless clamps
• All necessary hardware, isolation mount, and trim seal

Specifications

• Housing and tube: heat-resistant cross-linked polyethylene (XLPE)
• Filter: 9" tall, 360-degree radial flow
• Flow: 385 CFM @ 7" H2O, 35% over stock
• Install time: approximately 1 hour
• Part numbers: 56-70012R (Pro 5R), 56-70012D (Pro DRY S)

A cold air intake is one of the best first mods for a 3rd gen, and it stacks perfectly with a throttle body spacer and an OTT tune. Questions about which filter media fits how you use your truck? Reach out and we'll help you get it dialed in.